AKDY AK610I36 Installation Manual

1 30" AND 36" ISLAND-MOUNT RANGE HOOD Universal Installation Instructions and Use & Care Guide For questions about features, operation/

10 Complete Preparation 1. Determine the required location for the home power supply cable and drill a ½" (1.3 cm) diameter hole for wire acces

11 6. Install the inner support frame to the holes on the range hood body with M4*12 screws. 7. Remove all protective film from the duct cov

12 8. Install Inner and outer duct covers on the range hood body 9. Install the outer support frame on to the ceiling with four 7.5*52

13 INSTALL RANGE HOOD 1. Using 2 or more people lift the range hood assembly and attach it to the mounting bracket with M4*9.

14 COMPLETE INSTALLATION(FOR NON-VENTED(RECIRCULATING) INSTALLATION ONLY Step 1: Do not install exhaust pipe, remove the grease filters, and locate

15 RANGE HOOD USE The range hood is designed to remove smoke, vapors, and odors. For best results, start the hood before cooking. After, the cooking

16 RANGE HOOD CONTROLS Operating the lights The On/Off light button controls both lights. Press once for on and again for off. Operating the

17 RANGE HOOD CARE Cleaning IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace panel filters

18 Non-Vented (recirculating) Installation Filters: The carbon filter is not washable. It should last up to 6 months with normal use. For replacement

19 TROUBLE SHOOTING Potential Effect of Failure Potential Cause(s) Recommended Action(s) Lamp does not turn ON Electronic Control does not work.

2 TABLE OF CONTENTS RANGE HOOD SAFETY ...2 INSTALLATIO

20 - Hold and press main connectors attached in the white plastic. - Push inwards the motor/lamp connectors until the locking system on connectors is

21 SHOPRANGEHOODS.COM MAJOR APPLIANCE WARRANTY LIMITED WARRANTY For three year from the date of purchase, when this major appliance is operated and

3 IMPORTANT SAFETY INSTRUCTIONS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, READ THE FOLLOWING: Use this unit only

4 INSTALLATION REQUIREMENT TOOLS AND PARTS REQUIREMENTS Electrical drill or ratchet driver 1/2” drill bit for drilling pilot holes 1 ¼” drill bit fo

5 LOCATION REQUIREMENTS IMPORTANT: Observe all governing codes and ordinances. Have a qualified technician install the range hood. It is the install

6 INSTALLATION DIMENSIONS A. Countertop height B. Hood height from ceiling to bottom of the range hood filter surface: D-A-C=B C. 29” (73.66 cm)

7 VENTILATION REQIUREMENTS Range hoods must be ventilated to the outdoors, except for non-vented (recirculating) installations. Do not ventilat

8 Calculating Vent System Length To calculate the length of the system you need, add the equivalent feet (meters) for all vent pieces used in the sy

9 INSTALLATION INSTRUCTIONS PREPARE LOCATION Lay out the vent duct system before installing the range hood to determine the best routing for the